CBT Ball Separator |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
| POSITION |
+ |
- |
|
|
CBT Ball Separator1524 viewsThis is a rope ball separator, similar to the commercial leather ones, but with several advantages. Here is an example of the commercial leather ones:
http://www.extremerestraints.com/snap-on-cock-and-ball-harness_1952.html
The rope version has the advantage that it always fits. The leather ones have snaps, and while they might have multiple snaps for adjustment, the range of adjustment is not very wide. And there's always the danger of getting a flap of skin caught in the snaps, which is really painful.
This one always fits, is inexpensive, and can be made on the spot from a short length of cord.
|
|
Step 11690 viewsTo make the ball separator, you will need a few feet of cord, like parachute cord or sash cord. You could probably use long leather bootlaces, but they have a lot more resistance and tend to bite into the skin uncomfortably. And, of course, you will need a cock and some balls. Here we are using a fake cock and balls, since we can't show real ones on the website. The ball separator is a lot more effective and impressive when you are using the real thing.
When you are tying this, be sure to check with your partner about how tight to tie it, since different men like different amounts of tightness and/or pain.
|
|
Step 102682 viewsGrabbing both sides of the cord that goes under the other two cords, gently pull it down so it is at the bottom of the balls, next to the one you did on the other side.
|
|
Step 112664 viewsRunning the cord ends under the ropes around the cock and balls will have loosened them, so pull the ends of the loops at the top of the balls snug.
|
|
Step 122589 viewsBring the two loops together, running them between the balls.
|
|
Step 132369 viewsPull on the cord ends coming out below the balls until the two loops disappear and the balls are separated. This works much more effectively with real balls than it does with the monoball on our fake cock.
|
|
Step 142167 viewsPull the two cord ends out to the sides.
|
|
Step 152074 viewsBring them around to the top of the balls and cross one end over the other.
|
|
Step 162011 viewsPull them snug.
|
|
Step 172040 viewsNow cross the ends the other way, making a square knot.
|
|
Step 182310 viewsYou can continue bringing the ends around under the balls, then crossing them at the top. Each turn will put a little more pressure on the balls. You can continue this till you run out of cord, or you can take the ends and use them as a leash, or tie marling-hitches around the cock with them. (See the Marling-hitch CBT tutorial.)
Enjoy...
|
|
Step 21862 viewsStart by making a large overhand knot in the cord.
|
|
| 19 files on 2 page(s) |
|
1 | |
|
